Transformer winding machine has different ways of winding, but many consumers are not particularly aware of this, their different winding methods are mainly the following points:

1, transformer winding machine winding circular coil matters needing attention

This type of coil is a common coil, there are mainly hollow coil and coil with skeleton two, this kind of coil winding mode is relatively simple, it is not high on the position of the row wheel, can be in the front of the coil, can also be in the back of the coil, in the transformer winding machine set on time to pay attention to the following

Points:

(1) Increase the modification value of wire diameter appropriately according to the process requirements, which is used to adjust the spacing between lines

(2) When setting the width, pay attention to the deformation of the skeleton. If it is a spawn coil, the width should be appropriately reduced

(3) the tension adjustment is moderate, not too large or too small.

2, transformer winding machine winding square coil precautions

Typical is the motor stator coil, the coil is characterized by wide big small diameter, wire diameter is generally greater than 0.5 mm, pay attention to when this kind of coil winding winding speed control and tension control, general wiring in the box seat for wheel in the back of the coil, such outlet position to avoid part of puffiness, and in the middle of the coil winding speed should make an adjustment according to the coil diameter range and line diameter,

Generally, the larger the diameter of the coil winding speed is slower, speed through fast will cause the transformer winding machine chestnut and affect the quality of the coil.